Oil and grease on the steel surface must be removed using a suitable method, salts and other contaminants by (high pressure) fresh water cleaning prior to blasting. After blasting, clean the surface carefully from abrasives and dust. Abrasive blasting is the most effective method. Ensure surfaces are completely dry in depth and free of dirt, oil, grease, or other contamination. On old steel surfaces having been exposed to salt water, excessive amounts of salt residues in pitting may call for wet abrasive blasting followed by dry abrasive blasting. CLI Prime - RO41 may be over-coated with conventional paints or two-pack epoxy paints/Polyurethane paints. Over coating can be done after 6 - 8 hrs; however, it is recommended to coat after 12 - 24 hrs of application of primer to obtain superior performance. Better adhesion and flexibility.

The product should not come in contact with the skin and eyes, or be swallowed. Ensure adequate ventilation and avoid inhalation of vapours as some people are sensitive to resins, hardeners, and solvents. Wear suitable protective clothing, gloves, and eye protection. In case of contact with skin, rinse with plenty of clean water, then cleanse with soap and water. Do not use solvent to clean the contacted area. In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice. If swallowed, seek medical attention immediately - do not induce vomiting.