For new steel surfaces, blast clean to a surface profile not exceeding 65 microns. For old steel surfaces, blast clean or use mechanical tools, manual chipping, and wire brushing to remove loose rust. Avoid excessive burnishing of steel. Thoroughly dust down the surfaces and remove grease, oil, and other contaminants using AC thinner. Apply Coat MIO on a touch-dry cleaned and primed steel surface. Stir Comp A and Comp B separately. If settling is observed in Comp A, loosen the settled material with a hand stirrer followed by a power-driven stirrer for quick homogeneous mixing. Mix the hardener gradually into the base under continuous stirring until a homogeneous mix is achieved. Apply the mixed material by brush or roller.

Use a mask, nose cover, and hand gloves during application.
Clean hands with soap and water after application.
Ensure adequate ventilation and avoid inhalation of vapors, as some people are sensitive to resins, hardeners, and solvents.
Avoid contact with skin and eyes. In case of contact with eyes, rinse immediately with plenty of clean water, cleanse with soap and lukewarm water, and seek medical advice. Do not use solvent to clean the contacted area.
Prevent swallowing. In case of swallowing, seek medical attention immediately. Do not induce vomiting.