FEATURES

• Creates a positive bond between the substrate and most water based coatings
• Can be used on substrates like new and old concrete, timber and compressed fibre boards

TYPICAL APPLICATIONS

New and old concrete.
- Timber.
- Compressed fibreboards.
- Primer for acrylic coatings.

APPLICATION REQUIREMENTS

Substrate Preparation
The surface to be coated should be dry, clean, sound and free from oil, grease and flaking paint. New concrete should be left a minimum of 28 days and new render a minimum of 7 days before application commences. All cracks or holes exceeding 2mm are to be repaired before application commences.

Application
Apply with brush, long nap roller or conventional spray. Ensure that the coating is applied evenly at the recommended coverage rates. Allow a drying time of at least one hour.

LIMITATIONS

- Do not apply AT 109 if the temperature is below 10°C or above 35°C.
- Primed surfaces should preferably be overcoated within the same day of application to avoid intercoat contamination.

COVERAGE

Approximately 6 m²/litre. Coverage rate may vary depending on the porosity of the surface.

PACKAGING

5 Litres

CLEAN UP

Clean all equipment in fresh water after use.

TECHNICAL DATA

SAFETY DIRECTIONS

AT 109 is non-toxic. Avoid contact with skin and inhalation of the vapour. Wear protective eye/face protection and gloves when handling. Provide adequate ventilation. Wash off splashes with clean water. If irritation persists, seek medical advice.

STORAGE AND SHELF LIFE

AT 109 has a shelf life of 12 months in unopened containers stored at 20°C.

DISCLAIMER

The technical details, recommendations and other information contained in this data sheet are given in good faith and represent the best of our knowledge and experience at the time of printing. It is your responsibility to ensure that our products are used and handled correctly and in accordance with any applicable Australian Standard, our instructions and recommendations and only for the uses they are intended. We also reserve the right to update information without prior notice to you to reflect our ongoing research and development program. Country specific recommendations, depending on local standards, codes of practice, building regulations or industry guidelines, may effect specific installation recommendations.

The supply of our products and services is also subject to certain terms, warranties and exclusions, which may have already been disclosed to you in prior dealings or are otherwise available to you on request. You should make yourself familiar with them

DISPOSAL / SPILLAGE

Spillage of any of the component products should be absorbed onto sand or other inert materials and transferred to a suitable disposable vessel. Disposal of such spillage or empty packaging should be in accordance with local waste disposal authority regulations.

CONDITIONS OF SALE

Sold subject to the Company's conditions of sale which are available on request.

NOTE

The information supplied in this datasheet is based upon extensive experience and is given in good faith in order to help you. Our Company policy is one of continuous Research and Development; we therefore reserve the right to update this information at any time without prior notice. We also guarantee the consistent high quality of our products; however as we have no control over site conditions or the execution of the work, we accept no liability for any loss or damage which may arise as a result thereof.