ADVANTAGES

• Provides a transparent curing film for new concrete.
• Seals concrete surfaces to protect from the effects of weathering.
• Helps eliminate dusting and hardens concrete surface by promoting proper cement hydration.
• Resistant to yellowing.

APPLICATION

• Interior and exterior concrete.
• Curing compound for fresh concrete.
• Sealing old concrete.

APPLICATION METHODOLOGY

• Concrete surface must be clean and free of standing water. Remove any sealer or other material that may prevent absorption of the CLI Cure WE - 10C.
• Requires no pre-blending and should be used directly from the container.
• Apply at a uniform coverage by spray or roller application. Product may be sprayed with a hand held “pump-up” sprayer or with an airless industrial sprayer.
• If roller applied, use a short napped, solvent resistant sleeve.
• Allow the product to dry 4-6 hrs before exposure to traffic.
• Do not apply to concrete surfaces at ambient temperature below 4 °C. Warm material to a minimum temperature of 10 °C before use.
• Do not apply over bleed water or free standing water.
• Do not apply over concrete to receive concrete toppings, epoxy, or urethane based coatings or adhesives.
• For best cure of freshly placed concrete, apply CLI Cure WE - 10C as soon as possible after finishing operations and / or immediately after the disappearance of the “sheen” of surface moisture.
• When applying on old concrete, the surface must be clean and dry. Remove contaminants and stains such as waxes, grease and oil with strong soaps or caustics rather than acids. Badly worn or porous areas may need a second application to attain a uniform seal and surface gloss. CLI Cure WE - 10C may be placed on top of a previous coat of the same product. The surface must be clean and dry for proper adhesion.

CHARACTERISTICS

CLEANING & MAINTENANCE

Clean tools and equipment with water before the material hardens.

HEALTH & SAFETY

• Use mask, nose cover and hand gloves during application.
• Clean hands with soap water after application.
• Ensure adequate ventilation and avoid inhalation of vapours as some people are sensitive to resins, hardeners and solvents.
• Avoid contact with skin / eyes. In case of unlikely contact with eyes, rinse immediately with plenty of clean water, then cleanse with soap and lukewarm water and seek medical advice. Do not use solvent to clean the contacted area.
• Prevent swallowing. In case of unlikely swallowing, seek medical attention immediately. Do not induce vomiting.

PACKING

Available in 20 L & 200 L drum.

STORAGE AND SHELF LIFE

Store in a cool dry place under shed away from heat. The shelf life of product is 9 months in original unopened sealed condition.

CONDITIONS OF SALE

Sold subject to the Company's conditions of sale which are available on request.

NOTE

The information supplied in this datasheet is based upon extensive experience and is given in good faith in order to help you. Our Company policy is one of continuous Research and Development; we therefore reserve the right to update this information at any time without prior notice. We also guarantee the consistent high quality of our products; however as we have no control over site conditions or the execution of the work, we accept no liability for any loss or damage which may arise as a result thereof.