ADVANTAGES

• Excellent resistance to acid and alkali vapours.
• Low VOC material.
• Bonds well at low temperature & humidity.
• Short re-coating time.

APPLICATION

• Excellent anti-corrosive coating for all steel and concrete structures exposed to acid / alkali fumes emanating at high temperature, like in Ammonium Sulphate / Annealing / Acid Plants.
• Leather processing units, fertilizer plants, are some of the areas where Meta Kote 16P will work efficiently.

APPLICATION METHODOLOGY

• Remove dust, flakes, oil, grease or other foreign particles by jet or dry air and clean the surface to make it smooth before applying Meta Kote 16P. Surface of steel must be prepared as per the NACE (National Anti-Corrosion Engineers) or SSPC (Steel Structure Protection Council) guidelines. For non immersion purpose near white surface is adequate while for immersion service white metal surface is desired. Surface of steel and concrete must be free from dust, oil, soap and greasy material.
• Prime the surface by suitable Primer for concrete surface and CLI Prime Zn 40 for metal surface.
• Allow the primer to dry completely before applying Meta Kote 16P.
• Stir drums of each component thoroughly for homogeneousness with hand drill type stirrer to ensure dispersal of any settled filler for about 5 minutes for a 15 L pack. Then mix component A and Component B in the ratio of 2 : 1 by volume and stir for homogeneousness at slow speed.
• Place the spiral blade at the bottom of the container before starting the mixer. This will help avoiding inducting air into the mass. Slowly move the stirrer head up to the surface while stirring. Do not remove the blade while still spinning. This procedure is continued for 5 minutes up and down to have a homogeneous mixing. Allow the mix 10 minutes, then stir again gently with a hand stirrer to ensure uniformity and begin application.
• The mix can be applied by brush or spray with medium or short nap squeegee rollers.

CHARACTERISTICS

HEALTH & SAFETY

• Use goggles and hand gloves during application
• Clean hands with warm soap water after application. .

PACKING

Available in 4.5 L and 15 L unit pack with 2 components.

STORAGE AND SHELF LIFE

Keep in cool and dry place, under shed, away from heat.

CONDITIONS OF SALE

Sold subject to the Company's conditions of sale which are available on request.

NOTE

The information supplied in this datasheet is based upon extensive experience and is given in good faith in order to help you. Our Company policy is one of continuous Research and Development; we therefore reserve the right to update this information at any time without prior notice. We also guarantee the consistent high quality of our products; however as we have no control over site conditions or the execution of the work, we accept no liability for any loss or damage which may arise as a result thereof.